The Remember Operation setting controls how a product that already has visited an operation should act when it is addressed back to that same operation again.
A carrier will return to the same operation after any of the following commands are used
Abort Operation / Recycle Carrier
Aborts current operation for carrier in work position and sends it for a recycle
Only works on primary terminal. On a loading station, the carrier will always be sent back to the same station. On other stations, the carrier can go to any station valid according to the route and the addressing strategy.
Use of recycle function can be limited. See Topic: Recycle Limit. Limit can be ignored with Permission: Ignore Recycle Limit.Abort Operation + Send to inspection
Aborts current operation for carrier in work position and sends it for inspection on a given route.
🔒 Requires Permission 0034 • Send to InspectioninspectionRouteCode Route code of inspection route to send carrier on
Abort Operation + Send to repair
Open the fault registration menu. If a fault is registered, the current operation will be aborted.
🔒 Requires Permission 0036 • Register FaultAfter the repair has been made, the carrier will return to this operation.
Changing station work position
It can be configured on three different levels, which are from least to highest priority:
System Default → Operation Group → Operation
- If the operation setting is not set, the operation group setting will be used
- If the operation and operation group settings are not set, the system default value will be used
Setting values are one of the following
None
Nothing is remembered and carrier will be addressed according to the addressing strategy of the operation.
Station
The station is remembered and the carrier will if possible try to go back to the same station it was previously. If the station is blocked, full or cannot be sent to for some other reason, the carrier will go to a different open destination.